ROW POWER is a clean, regulated, and protected power solution for eurorack systems.
ROW POWER 40 provides 40W of power, suited for up to two typical eurorack rows.
Connect your modules via flying-bus cables, or connect the ROW POWER to a Distro Board.
Daisy-chain multiple ROW POWERS to use a single power brick for multiple rows.
Each row will be independently regulated and protected for ultra-low cross-talk between rows.
Rows can also be hot-swapped (plugged/unplugged without powering the whole system down).
- Two power jacks for daisy-chaining multiple Row PowerS: a common laptop-style power brick could power 3-5 rows (typical)
- On/off switch cuts power without interrupting the daisy-chain
- Row Power 30 (white panel) provides more than enough power for a 84HP or 104HP row of modules.
- Row Power 40 (black panel) is suited for up to 2 typical eurorack rows
- Ultra-clean: Each rail is separately regulated with high-grade components
- Runs cool: Row Power is efficient so it won't heat up your system. Electronics like to chill!
- Skiff-friendly: only 28mm (1.1") with power connectors installed.
- CV/Gate headers for expansion
- PCB pads for blade tabs for power entry, to be used in custom installations (e.g. if the 4HP panel is not used)
Row Power 40: +12V @ 1.5A, -12V @ 1.25A, +5V @ 1.5A
- Powered by laptop-style DC power supply: 2.1mm barrel, positive center, 15V-20V.
- A 90W power brick typically powers about 416HP (4 rows of 104HP).
- 24mm deep (0.96"), up to 28mm (1.1") with power cable
- Module does not draw current